The installation of a bathroom vanity with sink is a project most owners can achieve with confidence. Regardless of the brand or model of the box, the installation requires securing them to a wall. The vanity top and the sink is where the installation varies. In any case, however, the space you have in your bathroom plays the most important role in the installation of a bathroom sink and toilet. Read the instructions that come with the tap set chosen for this project, as they differ from one brand to another. The water supply lines and drainpipe toilet kit are not differentiated enough to make installation difficult.
ideas for install bathroom vanity with sink, measure from the ground to the center of the drain pipe protruding from the wall. Write the measurement on the wall next to the pipe. Repeat this with the water supply shut-off valves. Place the end of the tape measure on the bottom of the side of the dresser. Mark the measurements of the height of the drain pipe and water supply shut-off valves. Put the carpenter’s square on the marks and draw lines through the back of the vanity. Mark the lines of the holes to install the drain pipe supply and water shutoff valves with the measurements you have written on the wall. If the vanity is a separate bathroom cabinet, center the drain tube with the vanity and mark the water supply shutoff valves accordingly.
then for best bathroom vanity and sink, perform the drills for the supply of drain pipe and water cut valves with the right drilling saw. This allows a clean cut holes instead of the uneven appearance of cut holes with a jigsaw. Set the vanity in place and fix it to the wall with 3-inch plaster screws. Install faucets in the sink according to the manufacturer’s instructions. Connect the water supply lines to the faucet. Place the vanity lid on the cabinet. It is fixed to the toilet with 1 ½ inch plaster screws by the corner blocks of the cabinet.
Connect the water supply lines for the water supply shut-off valves with a wrench. Locate the drain pipe drainage pipe connected to the sink drain, slide the P-trap from the drain pipe toilet kit over the drain pipe and secure it with the nut provided. then for measure the distance between the remaining connection of the P-trap and the drain pipe on the wall. Cut the straight piece of tubing remaining from the two-inch longer kit with a hacksaw. Slide the end of it into the drain pipe on the wall and the P-trap. Secure them together with the nuts supplied with the kit.